T

echnology / Frequently Asked Questions

 

 

Our products outperform other emergency water purifiers...	Expedition, X-Pack, LifePack and HydroWell    (Prices varies)	SeaPack ($99)	Lifesaver Bottle ($395)	Reverse Osmosis Hand Pumps ($800)
Can be trusted to eliminate viruses, bacteria and cysts to EPA standards in all brackish and muddy water	YES	YES	YES	YES
Can be trusted to eliminate, salt, viruses, bacteria and cysts to EPA standards in sea water	NO	YES	NO	YES
Affordable	YES	YES	NO	NO
Five year shelf life	YES	YES	NO	NO
No Clogging	YES	YES	NO	NO
No Pumping	YES	YES	NO	NO
No Chemical Flavor	YES	YES	YES	YES
Filters to less than 10 angstroms	YES	YES	NO	NO
Provides needed electrolytes	YES	YES	NO	NO

Do you need the drink syrup to make the systems work?
Our products work on the basis of Forward Osmosis. Forward Osmosis filtration must use an osmotic agent (Sugar or Salt) to create osmotic pressure and draw the water molecules through a semi-permeable membrane filter. Our syrup packs have been formulated to maximize filtration capabilities, enhance oral hydration and drink preservation.

How long can I store the filters and syrup?
All SeaPack, Expedition, LifePack, X-Pack and HydroWell syrups are now for five years.  Based on continued research, all syrup used for desalination and water filtration can be stored for five years when maintained below 90 degrees Fahrenheit.  All filters have an indefinite shelf life until used the first time.

How quickly can I produce safe drink and are there any ways to speed the production?
The reported hydration speed of the product was measured at 68°F without agitation. Warmer water and agitation allows water to move easily through the filter. Basic filtration delivery speeds for each product at standard and above standard temperatures are as follows:

 

Temperature is:	1.0°C	= 33.8°F
At this temperature, 0.5 liter of drink should be obtained in about 8.6 hours
Temperature is:	5.0°C	= 41.0°F
At this temperature, 0.5 liter of drink should be obtained in about 7.6 hours
Temperature is:	10.0°C	= 50.0°F
At this temperature, 0.5 liter of drink should be obtained in about 6.5 hours
Temperature is:	20.0°C	= 68.0°F
At this temperature, 0.5 liter of drink should be obtained in about 5.0 hours
Temperature is:	30.0°C	= 86.0°F
At this temperature, 0.5 liter of drink should be obtained in about 4.0 hours
Temperature is:	35.0°C	= 95.0°F
At this temperature, 0.5 liter of drink should be obtained in about 3.6 hours

How do you know if the membrane is working properly?
Each and every product is tested for leaks under a positive pressure air test prior to packaging and shipping.  Products require a tight membrane filter and construction so that the osmotic pressure is always contained. In the rare case where a rupture or small hole develops in the membrane or construction under severe use, osmotic pressure is released and the osmotic filtration process stops. The product will not generate clean drink because the osmotic agent is flowing out into the dirty water. A full bag means a good bag and safe drink.

Does the membrane stop all chemical toxins?
At the behest of the Department of Defense (DoD), our initial products were engineered to stop biological pathogens. Biological pathogens are common in contaminated waters and even a small exposure, due to the rapid reproductive characteristics of bacteria and viruses, can result in severe illness. In addition our products perform very well against chemical toxins (as seen below):
 

Undissolved Radiological species (most common)	100% Rejection
Radioactive ions (less common)	85% Rejection
Chemical Warfare Agents (except CN)	95% Plus Rejection
Herbicides/Pesticides	95% Plus Rejection
Odors & Smells	95% Plus Rejection
Heavy Metals	85-90% Plus Rejection

Does the membrane stop all biological pathogens?
Our proprietary membrane is extremely effective at blocking all types of biological pathogens. Independent studies performed by both independent and military laboratories have consistently demonstrated that our products transform the worst possible life-threatening waters into clean, life-sustaining drink. As demonstrated in independent tests, our membranes meets or surpasses 6-log bacteria (99.9999%), 4-log virus (99.99%) and 3-log parasites and cysts (99.9%) reductions as specified by the EPA for water purifiers.

Will a forward osmosis membrane clog in dirty water?
Soldiers know that most indigenous water sources are highly turbid. Unlike other solutions, our proprietary membrane technology does not clog, even when confronted with the dirtiest of waters.  Pump systems indiscriminately force contaminants into their membranes causing the system to quickly clog and fail.  Chemical treatments cannot remove turbidity and are useless when confronted with this common condition. Our forward osmosis technology; however, does not unintelligently push water against the membrane, but rather water is selectively pulled through the membrane leaving other contaminants behind.   No pressure means no clogging.

Can I filter urine through the products and produce safe drink?
Our products are not designed to filter urine.  The system's strength is its ability to work with very turbid water sources. However, due to the extremely tight membrane, the our filters are capable of rejecting close to 90% of the salts in urine.  In a crisis, these products have been used to filter urine and have been credited for saving lives.

Page Two - Frequently Asked Questions